How to Image a Windows Device
HowConnect device to Image a Windows Devicepower and AddInternet toand Intunepower (Intune is only for Brand New Devices out of Box)on
1. After unboxing the device. Take asset tag off of blue tape and attach to device ( all in one and monitor have their own asset)
2. Make sure the asset is assigned in 1to1 Plus to the end user.
3. Plug up flash drive and Turn on All in One
If you need to add to Intune as a Brand New Only device do Step 4-6. If imaging only skip to Step 7
4. When you come up to the screen to pick right country or region- Shift + F10 to open a command prompt.
5. You will need to find the Drive the flash drive is on- most of the time it is -however you may have to do E, F, etc.
a. D: enter
b. This will tell you drive is not found or you can type in the command line
i. If it is a Staff device you will type Staff.cmd and enter
ii. If it is a student device you will type student.cmd
iii. If it is a Lab you will type Lab.cmd
6. When it is finished the computer will shut down.
7. Press F12 repeatedly until bootthe screenssystem comessettings up
8. Select the FlashUSB Driveflash (youdrive
Once competed all steps- remove flash drive Type EXIT and press enter key
Leave device on until completely finished will seebe 2at Partitions)login Pick Partition 1screen.
9. Click
*If device is not in intune or doesn't go to login screen (just sits at Windows Setup Screen
10. Click Install Now
11. Select Windows 11 Education (top of list and should be automatically selected) Next
12. Click checkbox and Next
13. Click Custom Install Windows
14. Delete all drives (highlight drive and click delete) once all deleted click Next
15. Laptop will go through Imaging process
16. Once AutoPilot is completed you do the setupCountry processscreen) stepsthen whensend readyRicky a message. Be prepared to give to a User. If it fails you willpossibly have to deletebring the Service Tag in Intune under Devices-Windows. Then start back over at Step 3.
in.